Sally CT - Bubble stripe Dragonfly card

  

Hi there! thought I would show you how I made this card.

I began by masking off the edges of a 6x6 card using stencil tape, and blending Peacock Feathers distress oxide ink over it.

Next I placed the bubble stripes grande inkable over the panel and blended over some Lucky Clover distress oxide ink.

I removed the tape and splattered water over it, blotting away the excess after a short time.

Once it was dry I stamped one of the freehand borders around the edge of the inked square.

I used versafine clair ink to stamp the sentiment, then set this aside

On a piece of parchment paper, I stamped the dragonfly in versamark ink and sprinkled detail silver embossing powder over it. I then heated it using a heat tool.

I used the coordinating dies to cut out the dragonfly and attached it to the inky panel on the card using matte medium. 

Here is the finished card again. Leaving the ends of the wings without glue, means they flutter a little as you move the card. 

I used:

6x6" blank card

stencil tape

Inkables Grande - Bubble stripes

Distress oxide ink in Peacock Feathers and Lucky Clover

Freehand Borders #1 stamp set

Mixed messages 4 stamp set

Versafine Clair ink in Black and Green

Dragonfly stamp set

Dragonfly dies

Parchment paper

Ranger fine detail silver embossing powder 

Matte Medium

Versamark ink

Thanks for looking!